34 - Flame Photometer

Sample rate 2 - 3.5ml/min Tubing materials Silicone and Tygon Required desk space for Instrument 50cm (H) x 45cm (W) x 45cm (D) For Safety reasons the Flame photometer requires 1m of unobstructed space above to allow dissipation of heat from the chimney. Instrument size XP Flame Photometer 51cm (H) x 39cm (W) x 35cm (D) Shipping 65cm (H) x 49cm (W) x 43cm (D) Weight XP Flame Photometer - 20kg Optimal range Single point calibration Na 0.1 - 60ppm K 0.05 - 100ppm Li 0.05 - 50ppm Ca 1.0 - 100ppm Ba 1.6 - 100ppm Multi Point Calibration Na 0.1 - 1000ppm K 0.05 - 1000ppm Li 0.05 - 1000ppm Ca 1.0 - 1000ppm Ba 5.0 - 3000ppm Reproducibility <1% Coefficient of variability for 20 consecutive samples over ten minutes at concentrations of 100ppm or less. (After instrument stabilisation). Specificity Na/K/Li = <1% to each other when equal in concentration at <100ppm Limit of detection (LOD) and limit of quantification (LOQ) LOD LOQ Na - 0.03ppm Na - 0.1ppm K - 0.02ppm K - 0.05ppm Li - 0.02ppm Li - 0.05ppm Ca - 0.3ppm Ca - 1ppm Ba - 1.6ppm Ba - 5.0ppm Time to stability Less than 15 seconds after sample is introduced into the flame. Ions measured Simultaneous measurement of Na, K, Li, Ca, Ba Interfaces USB 0-2.5 volt output (based on sample concentration linked to element of users choice) Optional 4-20mA output in place of the above Optional integrated printer .csv and .pdf generated reports and files via FP-PC software Recommended minimum warm up time based on ambient temperature 21ºC - 25 minutes Power requirements 100V - 250V AC at 50 or 60Hz automatically selecting Fuel requirement Propane, Butane or Natural Gas* regulated to 19Bar. Flow rate of 0.4l/min Readout LCD, four line, alpha numeric, back lit.